Wiring Harness upgrade for Fender P-Bass With Deluxe CTS 295 Series Pots and Mallory .047 Cap!
Premium replacement electronics for your Fender P-Bass! Each set is assembled, hand wired and soldered in the USA using premium parts. Upgrade your import bass electronics, or replace your old worn out parts with these premium replacement units! Simply attach your pickup wires, and bridge ground wire and you are ready to rock! All sets are signed by Dave Starr and have their own serial number.
Included in each Fender P-Bass PB295 control system:
2) CTS 250K "295 series" split shaft audio taper pot. 4 contacts on carbon wafer, lasts for 250,000 cycles. Threaded bushing is 0.25 inch tall, spline portion is 0.28 inch tall, 0.6 inch total height. Includes nut and star washer.
1) Mallory capacitor .047
2) brass sleeves to convert pots to solid shaft
4) Vintage style push back black (ground) and blue (hot) cloth covered wires, 22 gauge, custom made for us by GAVITT wire right here in the USA!
1) Switchcraft #11 input jack with heat shrink strain relief on both terminals.
1) Wiring diagram (see photo section)
1) Assembly template board
Note: Most guitars manufactured overseas in South Korea, Japan, China, Indonesia and Mexico use 6mm metric pots and have metric sized holes drilled. You will need to enlarge the pot holes to 3/8" to fit these CTS pots properly.
Premium replacement electronics for your Fender P-Bass! Each set is assembled, hand wired and soldered in the USA using premium parts. Upgrade your import bass electronics, or replace your old worn out parts with these premium replacement units! Simply attach your pickup wires, and bridge ground wire and you are ready to rock! All sets are signed by Dave Starr and have their own serial number.
Included in each Fender P-Bass PB295 control system:
2) CTS 250K "295 series" split shaft audio taper pot. 4 contacts on carbon wafer, lasts for 250,000 cycles. Threaded bushing is 0.25 inch tall, spline portion is 0.28 inch tall, 0.6 inch total height. Includes nut and star washer.
1) Mallory capacitor .047
2) brass sleeves to convert pots to solid shaft
4) Vintage style push back black (ground) and blue (hot) cloth covered wires, 22 gauge, custom made for us by GAVITT wire right here in the USA!
1) Switchcraft #11 input jack with heat shrink strain relief on both terminals.
1) Wiring diagram (see photo section)
1) Assembly template board
Note: Most guitars manufactured overseas in South Korea, Japan, China, Indonesia and Mexico use 6mm metric pots and have metric sized holes drilled. You will need to enlarge the pot holes to 3/8" to fit these CTS pots properly.
