STARR GUITAR SYSTEMS Wiring Harness Upgrade for Fender J-Bass: Series/Parallel Push/Pull Pot
- This wiring uses a push/pull pot in the tone position to switch the 2 pickups from parallel to series. Standard J-Bass wiring is parallel. Switching to series will give you a boost in output, and a boost in mid-range. Push Pull pot up = series, Push Pull pot down = parallel
Included in each SGS parallel/series Push Pull Pot Jazz Bass set:
2) USA made CTS 250K solid shaft audio taper volume pots
1) BOURNS 250K split shaft tone pot for series/parallel switching
1) Brass sleeve to convert BOURNS tone p/p pot to solid shaft if needed
1) Orange Drop .047 Capacitor 100 volt
5) Vintage style push back black (ground) and white (hot) cloth covered wires, 22 gauge, with a waxed braided cotton outer insulation.
1) Switchcraft #11 input jack with shrink wrap strain relief on both terminals.
1) Wiring diagram (sent via email)
1) Assembly template board
1) Wiring diagram (see photo section)
1) Assembly template board
Premium replacement electronics for your Fender or Fender style J-Bass! Each set is assembled, hand wired and soldered in the USA using premium parts. Upgrade your import bass electronics, or replace your old worn out parts with these brand new low priced replacement units! Simply attach your pickup wires, bridge ground wire and you are ready to rock! All sets are signed by Dave Starr and have their own serial number.
Note: Most guitars manufactured overseas in South Korea, Japan, China, Indonesia and Mexico use 6mm metric pots and have metric sized holes drilled. You will need to enlarge the pot holes to 3/8" to fit these CTS pots properly.
